I am connecting a Prop1 to an AP-16+. I'm using a 3 pin cable from p7 to the serial connector on the AP-16+. When I run my code with this
Symbols definition for code
' -----[ I/O Definitions ]-------------------------------------------------
SYMBOL Sio = 7
SYMBOL Baud = OT2400 ' baud jumper out
SYMBOL Yes = 1
SYMBOL No = 0
SYMBOL status = B0 ' status (B0 for bit access)
SYMBOL Playing = BIT7 ' 0 = idle, 1 = playing
SYMBOL id0 = B2
SYMBOL id1 = B3
SYMBOL id2 = B4
code:
SEROUT Sio, Baud, ("!AP16", %00, "V") ' get version
SERIN Sio, Baud, id0, id1, id2 ' receive ID string
Switches on the AP-16+ all off except the repeat switch
The program will pause here until I disconnect the cable. I have an ambient file, which plays and an SFX00 file which plays when I press the start button.
what is causing the AP-16+ not to respond or the prop1 to not send the signal properly?
Edit: Is there a way I can determine if the Prop1 isn't sending out commands to the AP-16+ properly?
The usual cause for errors are:
-- ULN influence on P7 (replace with ULN2003 or clip pin 1 of ULN2803)
-- P7 SETUP jumper in the DN position
-- bad cable connection
-- broken cable