Print Page - Connecting from Prop1 to DC-16+ for serial communication

Title: Connecting from Prop1 to DC-16+ for serial communication
Post by: phalon on October 22, 2012, 04:23:36 PM

I want to connect the prop1 to the DC-16+ for serial communication. I have found that I connect a cable to P7 on the prop1 and I have the the ULN2003AC chip in. What pins do I connect to on the DC-16+?
My options are the pins next to BRW or the pins next to serial, I am not able to find documentation on this, and they are both label serial in the documentation.

Title: Re: Connecting from Prop1 to DC-16+ for serial communication
Post by: bsnut on October 22, 2012, 04:44:32 PM

Welcome to the forums first off.

As you may know the DC-16 was replaced by the HC-8+, but the docs should be in the forums under this link http://www.efx-tek.com/php/smf/index.php?board=15.0 in the Documentation section. But, I have a copy on my computer and I will attach to this post for you. All the info on connecting to the Prop-1 is in this PDF.

Title: Re: Connecting from Prop1 to DC-16+ for serial communication
Post by: JackMan on October 22, 2012, 06:46:52 PM

QuoteMy options are the pins next to BRW or the pins next to serial, I am not able to find documentation on this, and they are both label serial in the documentation.

Either set of pins will work. There are 2 sets of pins to allow multiple boards to be daisy chained on a single serial line.

EFX-TEK

TEK Talk => I/O Support => DC-16 => Topic started by: phalon on October 22, 2012, 04:23:36 PM