John,
Thanks again for all the info. Quick question - what is the part number I need from Jameco (assuming you order from them) to make my own connections to the header pins?
p.s.
I blame you not one bit if you direct me to your pre-made cable.
Stehveo,
You can use our cables or build your own -- the Jameco part # is #100766. Jameco has shells as well; I usually keep 2- and 3-position shells on hand. Here are parts that you might want to order:
#100766 -- female crimp pin
#100812 -- 2-pin shell
#157382 -- 3-pin shell
#159266 -- crimper tool
Sorry if this sounds stupid, but is there a right way -vs- wrong way to use the crimp tool? I purchased the parts you mentioned half expecting there to be directions on the crimp tool on how to use it, but alas there are none. Can anyone help me before I ruin all my crimp pins?
CoffinBound
Follow the directions in this document:
http://www.parallax.com/dl/docs/cols/nv/vol1/col/nv8.pdf
Then... (here's what makes them bullet-proof). Heat the pin-socket at the crimp point with a clean soldering iron and then just sweat on the tiniest bit of solder; this will ensure a good connection that won't come apart. Those pins are designed for machines that use thousands of pounds of pressure and there is no way a human can duplicate that with a hand-tool; by using a bit of solder you connections will be good forever. If you use too much solder you might not be able to get the connector onto a pin, so go easy.
[Edit: 26 JAN 2008] The soldering job is easier if you apply a tiny bit of liquid flux to the connector (at the crimp point). Then you can put a little solder on the tip of your iron and touch it to the crimp point. The liquid flux will clean the joint -- we use it because apply the solder to the iron causes any flux in the solder to boil off. Clean the connection with 99% alcohol or flux remover. For single pins, I simply protect them with a piece of 3/32" heat shrink tubing.
Cool. Thanks for the good info. Maybe now I won't be throwing out the money I spent. 8)