Print Page - Prop SX/RC-4 and fog machine

Title: Prop SX/RC-4 and fog machine
Post by: youngti on September 27, 2009, 10:29:38 AM

I'm vamping up my sliding top coffin. I'm going to be using a Prob SX to turn on a Motor for 8.5sec's, Light, sound (using CAP200) and Fog machine. My question is I was planning on putting all of this inside the coffin. Do you think the FOG will mess up the boards with moisture? Trying to decide if I need to mount the electronics outside the coffin.

Thanks as always guys.

Title: Re: Prop SX/RC-4 and fog machine
Post by: JonnyMac on September 27, 2009, 10:58:48 AM

No, it won't hurt the boards. What we suggest, though, is mounting the boards vertically so that any accumulated moisture can run off. If you're really concerned, a Tupperware-type container is really easy to modify into a fairly moisture-proof container, and it's really cheap, too.

Title: Re: Prop SX/RC-4 and fog machine
Post by: youngti on September 27, 2009, 11:28:53 AM

UNBELVABLE! Sunday and you answered with in 2 minutes. YOU GUYS ROCK! This is one of the reasons I will not buy anything other than EFX-TEK controllers.

Thanks again

Title: Re: Prop SX/RC-4 and fog machine
Post by: JonnyMac on September 27, 2009, 12:12:56 PM

Maybe it means I need to get a life! We do appreciate your business, though.

EFX-TEK

TEK Talk => Prop-SX => Topic started by: youngti on September 27, 2009, 10:29:38 AM